20 N4680 2D Decoded Scan Engine User Guide
Control Character Output
This selection sends a text string instead of a control character. For example, when
the control character for a carriage return is expected, the output would display
[CR] instead of the ASCII code of 0D. Refer to ASCII Conversion Chart (Code Page
1252) on page 216. Only codes 00 through 1F are converted (the first column of
the chart).
Note: Control + X (Control + ASCII) Mode overrides this mode.
Default = Off
.
Keyboard Modifiers
This modifies special keyboard features, such as CTRL+ ASCII codes and Turbo
Mode.
Control + X (Control + ASCII) Mode On: The scan engine sends key combinations for
ASCII control characters for values 00-1F. Windows is the preferred mode. All key-
board country codes are supported. DOS mode is a legacy mode, and it does not
support all keyboard country codes. New users should use the Windows mode.
Windows Mode Prefix/Suffix Off: The scan engine sends key combinations for
ASCII control characters for values 00-1F, but it does not translate any prefix or
suffix information.
Default = Control + X Mode Off.
Control Character Output On
* Control Character Output Off
Windows Mode Control + X
Mode On
DOS Mode Control + X Mode On
To Next Page
Loading...
