98 N4680 2D Decoded Scan Engine User Guide
Code 93 Message Length
Scan the bar codes below to change the message length. Refer to Message Length
Description (page 86) for additional information. Minimum and Maximum lengths
= 0-80. Minimum Default = 0, Maximum Default = 80.
Code 93 Redundancy
If you are encountering errors when reading Code 93 bar codes, you may want to
adjust the redundancy count. Redundancy adjusts the number of times a bar code
is decoded before transmission, which may reduce the number of errors. Note that
the higher the redundancy count, the longer it will take to decode the bar code. To
adjust the redundancy, scan the Code 93 Redundancy bar code below, then scan a
redundancy count between 0 and 10 on the Programming Chart. Then scan the
Save bar code. Default = 0.
Code 93 Append
This function allows the scanner to append the data from several Code 93 bar
codes together before transmitting them to the host computer. When this function
is enabled, the scanner stores those Code 93 bar codes that start with a space
(excluding the start and stop symbols), and does not immediately transmit the
data. The scanner stores the data in the order in which the bar codes are read,
deleting the first space from each. The scanner transmits the appended data when
it reads a Code 93 bar code that starts with a character other than a space. Default
= Off.
To Next Page
Loading...
