42 N4680 2D Decoded Scan Engine User Guide
following bar code, then use the Programming Chart to read the alphanumeric
combination that represents that ASCII character. Scan Save to finish. Default = 12
[DC2].
End Character Activation After Good Read
After a bar code is successfully detected and read from the scan engine, the illumi-
nation can be programmed either to remain on and scanning, or to turn off. When
End Character Activation After Good Read is enabled, the illumination turns off
and stops scanning after a good read. If you scan Do Not End Character Activa-
tion After Good Read, the illumination remains on after a good read. Default = Do
Not End Character Activation After Good Read.
Character Activation Timeout
You can set a timeout for the length of time the illumination remains on and
attempting to decode bar codes when using Character Activation Mode. Set the
length (in milliseconds) for a timeout by scanning the following bar code, then set-
ting the timeout (from 1-300,000 milliseconds) by scanning digits from the
Programming Chart inside the back cover of this manual, then scanning Save.
Default = 30,000 ms.
* Do Not End Character
Activation After Good Read
End Character Activation After
Good Read
Character Activation Timeout
To Next Page
Loading...
