40 N4680 2D Decoded Scan Engine User Guide
CodeGate
®
When CodeGate is On, the trigger is used to allow decoded data to be transmitted
to the host system. The scanner remains on, scanning and decoding bar codes, but
the bar code data is not transmitted until the trigger is pressed. When CodeGate is
Off, bar code data is transmitted when it is decoded. Default = CodeGate Off Out-of-
Stand.
Mobile Phone Read Mode
When this mode is selected, your scan engine is optimized to read bar codes from
mobile phone or other LED displays. However, the speed of scanning printed bar
codes may be slightly lower when this mode is enabled. You can enable Mobile
Phone Reading for either a hand held device, or for a hands-free (presentation)
application.
Note: Global shutter engines are better for reading bar codes on cell phones and paper
since there are dual exposure controls to optimize the reading for each on every other
frame.
Left of
Presentation Centering
Window
Right of Presentation
Centering Window
* CodeGate Off
Out-of-Stand
To Next Page
Loading...
