N4680 2D Decoded Scan Engine User Guide 27
3
INPUT/OUTPUT SETTINGS
Power Up Beeper
The scan engine can be programmed to beep when it’s powered up. Scan the Off
bar code(s) if you don’t want a power up beep. Default = Power Up Beeper On -
Scanner.
Beep on BEL Character
You may wish to force the scan engine to beep upon a command sent from the
host. If you scan the Beep on BEL On bar code below, the scan engine will beep
every time a BEL character is received from the host. Default = Beep on BEL Off.
Power Up Beeper Off -
Scanner
* Power Up Beeper On -
Scanner
To Next Page
Loading...
