Honeywell N4680 - Page 224

204 N4680 2D Decoded Scan Engine User Guide
DotCode Message Length Minimum (1-2400) *1 DOTMIN#### 140
Maximum (1-2400) *2400 DOTMAX#### 140
Digimarc Barcode Decoder Attempts (0-10) *3 DIGSTR## 140
Off DIGENA0 140
On DIGIENA1 140
Uses ID Decoder then Both Decoders DIGIENA2 140
*Uses Digimarc Decoder then Both
Decoders
DIGIENA3 140
Uses ID Decoder then Alternates
Decoders
DIGIENA4 140
Uses Digimarc Decoder then Alternates
Decoders
DIGIENA5 140
Data Matrix Default All Data Matrix Settings IDMDFT 141
*On IDMENA1 141
Off IDMENA0 141
Low Contrast Data Matrix
Enhancements
*Low Contrast Data Matrix
Enhancements On
DPMENA1 142
Low Contrast Data Matrix
Enhancements Off
DPMENA0 142
Reflective Low Contrast Data Matrix
Enhancements On
DPMENA2 142
Data Matrix Msg. Length Minimum (1-3116) *1 IDMMIN 142
Maximum (1-3116) *3116 IDMMAX 142
Data Matrix Append *On IDMAPP1 142
Off IDMAPP0 142
Data Matrix Code Page Data Matrix Code Page (*51) IDMDCP## 143
Grid Matrix Default All Grid Matrix Settings GMXDFT 143
On GMXENA1 143
*Off GMXENA0 143
Grid Matrix Message Length Minimum (1-2751) *1 GMXMIN#### 144
Maximum (1-2751) *2751 GMXMAX#### 144
MaxiCode Default All MaxiCode Settings MAXDFT 144
*On MAXENA1 144
Off MAXENA0 144
MaxiCode Message Format Primary Message Only MAXFMT0 144
Primary Required, Secondary if
Available
MAXFMT1 144
Both Primary and Secondary Required MAXFMT2 144
MaxiCode Msg. Length Minimum (1-150) *1 MAXMIN 145
Maximum (1-150) *150 MAXMAX 145
Selection
Setting
* Indicates default
Serial Command
# Indicates a
numeric entry
Page