NFS2-3030 Programming Manual — P/N 52545:A 11/29/2005 15
Getting Started General Information
REFERENCE: Press this key to enter a maximum 20-character alphanumeric label that identifies the
user. Press the enter key on the display/keyboard to enter the information.
ENTER PASSWORD - Press to enter a new password. Enter up to eight alphanumeric characters,
then press enter. RE-ENTER PASSWORD will appear. Retype the password for verification.
ACCEPT: After entering all password information and retyping the password at the prompt, press this
soft key to save all the password information.
Incorrect or Forgotten Password
If a password is entered incorrectly, the panel will respond by displaying an INVALID
PASSWORD message and a code. The programmer may hit the escape key and re-enter the
password correctly. However, if the password has been forgotten, record the code and contact
NOTIFIER. After proper authentication, the master password can be determined by deciphering the
code. An example of the message that would appear on the display follows:
INVALID PASSWORD:
9066-21FS-7D78-5FA4-6163
Code
To Next Page
Loading...
Need help?
General
