74 NFS2-3030 Programming Manual — P/N 52545:A 11/29/2005
Alter Status Control On/Off Point Select
4.8 Control On/Off Point Select
This screen may be used to force an SLC control module off if it is on, or on if it is off.
Figure 4.15 Control On/Off Point Select Screen
Soft Keys
POINT: Press this soft key to enter the point address to be forced on or off.
NEXT/PREVIOUS SELECTION: Press to progress to the next or previous point on the loop.
ACCEPT: Press to continue to the Control On or Control Off screen.
4.8.1 Control Off
One of the following two screens will display when a point is selected and accepted in the previous
screen.
If the selected point is active, the Control Off screen will appear.
Figure 4.16 Control Off Screen
LAKEVIEW GENERAL HOSPITAL
SYSTEM NORMAL
10:22:34A FRI APR 22, 2005
POINT SELECT
POINT: NxxxLyyMzzz (MODULE)
NEXT SELECTION ACCEPT
PREVIOUS SELECTION BACK
NOTE: A module with a releasing Type ID can not be forced.
LAKEVIEW GENERAL HOSPITAL
SYSTEM NORMAL
10:22:34A FRI SEP 23, 2005
CONTROL ON/OFF: N114L03M052
AUTOMATIC ACTIVE
ELEVATOR RECALL EAST WING
FIFTH FLOOR Z000 CONTROL
FORCE OFF BACK
To Next Page
Loading...
Need help?
General
