Page 112 Foundation Fieldbus RMA803 Remote Indicator User's Guide Revision 4
8.6 Understanding simulation mode
About simulation mode jumper
If the process is not running, a simulation mode is available in the Remote Indicator which aids in
system debug. When simulation mode is enabled, user can simulate Field Diagnostic Alarm from
Resource Blocks.
Setting simulation jumper
A hardware jumper on the Communication Module assembly is set to enable or disable the
SIMULATE parameter. See Figure 23 for jumper location.
Table 36 shows how to set the simulation jumper on the Communication Module assembly.
Figure 23: Simulation Write Lock Jumper Location on Comms Module assembly
To Next Page
Loading...
