Page 22 Foundation Fieldbus RMA803 Remote Indicator User's Guide Revision 4
Table 10: Information Menus
<Return> Return to the Level 1 menu
Display
<Return>
Firmware Version
The firmware version of the Display
Module
Read Only
Elec Module
<Return>
Firmware Version
The firmware version of the Electronics
Module
Read Only
Protocol
The communications protocol of the
Remote Indicator:
Read Only
Model
<Return>
Model Key
Identifies the type and range of the
Remote Indicator
Read Only
Options
<Return>
Additional FB
Indicates the status of Enabled or
Disabled
Read only
Serial Number
Unique serial number of the Remote
indicator
Read only
License Key
License key to enable optional function
block
Write only
The integrated circuits in the Remote Indicator PWA are vulnerable to damage by stray
static discharges when removed from the Electronics Housing. Minimize the possibility of static
discharge damage when handling the PWA as follows:
Do not touch terminals, connectors, component leads, or circuits when handling the
PWA.
When removing or installing the PWA, handle it by its edges or bracket section
only. If you need to touch the PWA circuits, be sure you are grounded by staying in
contact with a grounded surface or by wearing a grounded wrist strap.
When the PWA is removed from the Remote Indicator, put it in an electrically
conductive bag, or wrap it in aluminum foil to protect it.
To Next Page
Loading...
Need help?
General
