Revision 4 Foundation Fieldbus RMA803 Remote Indicator User's Guide Page 67
Parameter Description
DISABLE_5 Parameter to switch off the input from being used. 0-Use, 1 -Disable.
DISABLE_6 Parameter to switch off the input from being used. 0-Use, 1 -Disable.
DISABLE_7 Parameter to switch off the input from being used. 0-Use, 1 -Disable.
DISABLE_8 Parameter to switch off the input from being used. 0-Use, 1 -Disable.
SELECT_TYPE Determines the selector action: First Good, Minimum, Maximum, Middle,
and Average.
MIN_GOOD The minimum number of inputs which are “Good” is less than the value of
MIN_GOOD then set the OUT status to “Bad”.
SELECTED The integer indicating the selected input number.
OP_SELECT An operator settable parameter to force a given input to be used.
UPDATE_EVT This alert is generated by any change to the static data.
BLOCK_ALM The block alarm is used for all configuration, hardware, connection failure,
or system problems in the block. The cause of the alert is entered in the
subcode field. The first alert to become active sets the Active status in the
Status parameter. As soon as the Unreported status is cleared by the
alert reporting task, another block alert may be reported without clearing
the Active status, if the subcode has changed.
LICENSE_STAT
US_IS
License status of the function block.
To Next Page
Loading...
