Honeywell SPZ-8000 - Bearing Pointer Source Selection; Waypoint Declutter Mode

Honeywell !!!!!!~.c’
6. C. (3) (b) Bearing Pointer Source Selection - The first row of this menu
is dedicated to selection of the bearing circle sources. The
second row of the menu is comprised of the bearing diamond
sources.
Selection of the left line select keys move the box
across the row (left to right) through the bearing sources.
With the box on the extreme right-hand source, the next
selection of the left line key,
removes the box from the menu.
This is how bearing pointers are removed from the display
(PFD/ND).
Another selection of this key, will bring the box
up
on the left
side of the row.
The right line select keys in the
first two rows operate the same except that the box moves from
right to left.
Selection of the AUTO mode forces the particular bearing
pointer source to be the same as the active navigation source.
The pilot’s AUTO selection appears on the bearing circle (No. 1
sources) pointer only as shown in Figure 6-10. The
copilot’s
AUTO selection
pointer only.
The bearing po
appears on the bear
nter power-up defau
ng diamond (No. 2 sources)
ts are:
Pilot
- AUTO
Copilot - AUTO
(c) Waypoint Declutter Mode -
The selection for this mode is
displayed on the DC CRT as ID WAYPT. This selection has
three
independent
modes as described:
I
ID WAYPT -
m
IDWAYPT -
IDWAYPT -
This is the power-up mode for this parameter.
With the box surrounding the entire mode, the
active flight plan waypoints and IDs are
displayed on the MAP display format.
This is the next selection of the line key.
With the box surrounding only the WAYPT
label, the active flight plan waypoints are
~;:~):yed without IDs on the MAP display
.
This is the next selection of the line key.
With both the ID and WAYPT labels unboxed,
the active flight plan waypoints and IDs are
not displayed on the MAP display format.
22-14-00
Page 176
Aug 15/91
Use or disclosure of information on this page is subject to the restrictions on the title page of this document,