Honeywell SPZ-8000 - WIND Display Selection; Vertical Profile; MAP Selections General

Honeywell !$!!!~.c’
6. C. (3) (f) WIND Display Selection
-
The WIND format can be selected for
display in either the vector or X-Y format as
shown in Figure
6-10.
The power-up default is X-Y format. By selecting the
line key, the box moves left to right as shown
below:
First
Second
Push
Push
r
>
XY
> VECTOR
> OFF
1
Third Push
(9) Vertical Profile
- The vertical profile mode can be selected
for display on the MAP mode format. The power-up default for
this mode is VERT PROF selected for display (boxed). This
function is an alternate action selection on the DC (i.e.,
boxed/unboxed).
(h) MAP Selections General - Bearing pointer and wind display
selections made on this menu also change the selections on the
COFIPmode menu, and will be reflected on the COMP display if
subsequently selected. Flight plan declutter selections made
on this menu are also changed on the PLAN mode menu, and will
be reflected on the PLAN display if subsequently selected.
22-14-00
Page 178
Aug 15/91
Use or disclosure of information on this page is subject to the restrictions on the title page of this document.