The LU-860 Lightning Sensor Controller is used to select the modes of
operation of the lightning sensor system.
The switch functions are
listed in Table 12-3.
OFF
All power removed.
STBY
Display is inhibited but the processor is
accumulating data.
LX
System is fully operational. All accumulated
lightning data is displayed.
CLR/TEST
Accumulated data is cleared from memory. After
3 seconds the test mode is initiated.
LU-860 Switch Functions
Table 12-3
22-14-00
Page 198:177
Apr 15/93
Use or disclosureof information on thispage issubject to the restrictionson the titlepage of thisdocument.
To Next Page
Loading...
