NOTE : The following RF connector kits contain two RF connectors and two
retainer rings.
The retainer rings can be ordered separately under
Part No. 0493-18.
IK-858RF Part No. 7500436-90X
RF Connector Kit for use with Mounting Tray. Two kits required for
each
MLS Receiver installation.
Select from the following:
Part No. 7500436-907 - Connector Kit with RF Straight Connector
(RG-214)
Part No. 7500436-908 -
Connector Kit with RF Right Angle Connector
(RG-214)
Part No. 7500436-909
- Connector Kit with RF TNC Adapter Connector
ML-850 MLS Receiver
Leading Particulars
Table 14-1 (cent)
The ML-850 MLS Receiver decodes and
processes data from an MLS ground
station and provides an accurate indication in both azimuth (equivalent to
localizer) and elevation (equivalent to glide slope) of the deviation from
the desired flight path.
The deviation data is displayed on the PFD and is
output to the FZ-820 Flight Guidance Computer for use in the approach
mode
of operation.
The ML-850 operates in the frequency range of 5031.0 to 5090.7
MHz on 200
channels spaced 3000 kHz apart.
Selection of the desired azimuth and
elevation angle and tuning is accomplished with the CM-850 MLS Con-
trol/Display Unit.
The ML-850 provides ARINC 429 digital outputs (Table 14-2) that conform to
the data standards of ARINC characteristic 727
for MLS receivers.
22-14-00
Page 198.193
Apr 15/93
Use or disclosure of information on this page is subject to the restrictions on the title page of this document.
To Next Page
Loading...
