Honeywell Vigilon 4 loop

Password or PIN code -----------------------53
How to create an Engineer PIN -----------------------54
How to change the Customer PIN ----------------------54
How to erase a PIN ----------------------------- 54
Address allocation ------------------------55
Address allocation with Loop circuit end 1 connected -------------55
Allocation faults ------------------------------ 56
How to re-allocate addresses to a loop circuit -----------------56
Address allocation with Loop circuit End 2 connected -------------56
Plexus Devices ------------------------------- 56
SAFE Addressing -------------------------57
To SAFE address a device -------------------------- 57
To convert from SAFE to soft address -------------------- 57
Checking a loop map -----------------------58
To find devices on a loop circuit ----------------------- 58
Non Volatile Memory (NVM) -------------------59
NVM Hardware Write protect ------------------------ 59
NVM Software - 'write protect' and 'unprotect' ----------------60
To back up loop data to NVM ------------------------ 60
To recover loop data from NVM ---------------------- 61
How to electrically erase the NVM ----------------------61
2km Loop circuit - tests using LDT ----------------62
Loop diagnostic tool ---------------------------- 62
How to [Repair] a loop circuit ------------------------62
Loop resistence measured by the panel --------------------62
1km Loop circuit - manual tests ------------------62
Loop resistance and capacitance ----------------------- 62
Loop circuit tests -------------------------63
Loop short circuit test ---------------------------- 63
Ground break test ------------------------------ 63
Positive line break test---------------------------- 64
Earth fault test ------------------------------- 64
Checking device STATUS---------------------65
Loop Device Status ----------------------------- 65
Plexus Device Status ---------------------------- 67
Device checks --------------------------68
Checking the time averages ------------------------- 68
Checking the Exception/Subfault codes--------------------70
Condition Codes for S-Quads (Exception / Sub Fault codes) ---------71
Pre Fire, Fire and Super fire --------------------72
S-Quad Sensor with VAD - STATES VAD (current range of devices) 73
S-Quad Sensor with Strobe - STATES (legacy devices) -------74
S-Quad Heat sensor STATES ------------------------ 75
S-Quad Dual Optical & Heat / Optical & Heat sensor STATES --------75
S-Quad Dual Optical, Heat & CO sensor STATES --------------76
S-Quad Optical sensor STATES ----------------------- 76
Beam sensor STATES-----------------------77
Interface Unit STATES ----------------------78
Single channel interface input STATES ------------------- 78
4 - Channel Interface Unit STATES ---------------------78
34000 range of sensors STATES (legacy devices)----------79
Optical heat sensor (plus sounder) STATES (34000 range) ----------79
Heat sensor STATES (34000 range) ---------------------80
Installed equipment tests----------------------81
Preparation --------------------------------- 81
Communication to site occupants ----------------------81
Commissioning Tool ---------------------------- 81
Plant equipment------------------------------- 81
Zone 'Test' mode (for EN panels only) -------------------- 81
'Commission' mode (for BS panels only) -------------------81
Fire Sensors -------------------------------- 82
Manual Call Points ----------------------------- 82
Interface Units ------------------------------- 82
S Cubed ---------------------------------- 83
Repeat panel (Loop connected) -----------------------83
Mimic Panel -------------------------------- 83
Mains powered DAU and micro DAU (Legacy devices) ------------83
VIGILON Compact VA system (Legacy system) ---------------83
Deviations from standards -------------------------- 83
4188-856_issue 7_07/15_Generic Vigilon (Compact + VA) Comms. 3
Vigilon 4/6 loops & Compact (VA) panels & network nodes
Contents