Honeywell XNX - 2�5 Configuring The Xnx Universal Transmitter; Select Language

XNX Universal Transmitter
Section 2 - Installation and Operation
57
TechnicalManualforcalibrationinformationP/N
2104M0506)�
8�Resetanyfaultsthatappearinthetransmitter’sdisplay�
TheXNXtransmitterandSearchlineExcelsensorarenow
readytomonitor�
2.5ConguringtheXNXUniversal
Transmitter
TheXNXUniversalTransmittercanbeconguredviathefront
panelbyusingthemenusavailableinCongureMenu�For
informationonaccessingandnavigatingthemenus,seeSection
1�4�1�
2.5.1 CongureMenu
FunctionsintheCongureMenuandthesecuritylevelsrequired
tochangethemareexplainedinthistable�
Symbol Description
Security
Level
Symbol Description
Security
Level
SelectLanguage 1 CalibrationInterval 2
SetDate&Time 1
✓
AcceptNewSensor
Type
2
SetmVSensorType 2 BeamBlockOptions 2
SetmASensorType 2 PathLength 2
GasSelection 2 UnitID 2
Range&Alarms 2 RelayOptions 2
Latching/Non-
latching
2 FieldbusOptions 2
SetUnits 2 CongureSecurity 2
mALevels 2
Warning: Whenconfiguringorcommunicatingwiththetransmitter
usingthefrontpaneldisplays,resumemonitoringbyexitingall
menusandreturningtotheGeneralStatusmenumanually.Notime
outsareinvoked.
Note: WiththeexceptionofInhbitMode,gasmeasurement
continuesinthebackgroundallowinguserstonavigatescreens
withouttakingthetransmitteroffline.
Select Language
AvailablelanguagesfortheXNXtransmitterareEnglish,Italian,
French,German,Spanish,Russian,Mandarin,andPortuguese�
Figure 64. Select Language Menu
Differentscreensareusedtodisplayeachoftheeightavailable
languages,onelanguageperscreen�Eachlanguagescreen
willappearinthreelanguages:theselectedlanguage,Russian,
andMandarin�Toselectanewdisplaylanguage,usethe
 
switchestonavigagethroughtheselections�Use
✓
tomakethe
selectionor
✖
todiscardtheselectionandreturntotheprevious
menu�
