HP 830

115
Field Descri
p
tion
DEFAULT Indicates whether a type of TLV is sent through a port by default.
Basic optional TLV
Basic TLVs:
• Port description TLV.
• System name TLV.
• System description TLV.
• System capabilities TLV.
• Management address TLV.
IEEE 802.1 extended TLV
IEEE 802.1 organizationally specific TLVs:
• Port VLAN ID TLV.
• Port and protocol VLAN ID TLV.
• VLAN name TLV.
IEEE 802.3 extended TLV
IEEE 802.3 organizationally specific TLVs:
• MAC-Physic TLV.
• Power via MDI TLV.
• Link aggregation TLV.
• Maximum frame size TLV.
LLDP-MED extend TLV
LLDP-MED TLVs:
• Capabilities TLV.
• Network Policy TLV.
• Extended Power-via-MDI TLV.
• Location Identification TLV.
• Inventory TLV, including hardware revision TLV, firmware revision TLV,
software revision TLV, serial number TLV, manufacturer name TLV,
model name TLV, and asset id TLV.
lldp admin-status
Use lldp admin-status to specify the LLDP operating mode for a port or all ports in a port group.
Use undo lldp admin-status to restore the default LLDP operating mode.
Syntax
lldp admin-status { disable | rx | tx | txrx }
undo lldp admin-status
Default
The LLDP operating mode is TxRx.
Views
Layer 2 Ethernet interface view, port group view
Default command level
2: System level
Parameters
disable: Specifies the Disable mode. A port in this mode does not send or receive LLDP frames.