HP 830

21
port-group manual
Use port-group manual to create a port group and enter port group view.
Use undo port-group manual to remove a port group.
Syntax
port-group manual port-group-name
undo port-group manual port-group-name
Default
No port groups exist.
Views
System view
Default command level
2: System level
Parameters
port-group-name: Sets the port group name, a string of 1 to 32 characters.
Examples
# Create port group group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1]
unicast-suppression
Use unicast-suppression to set the unknown unicast suppression threshold on an Ethernet interface or a
group of Ethernet interfaces.
Use undo unicast-suppression to restore the default.
Syntax
unicast-suppression { ratio | pps max-pps }
undo unicast-suppression
Default
Ethernet interfaces do not suppress unknown unicast traffic.
Views
Layer 2 Ethernet interface view, port group view
Default command level
2: System level
Parameters
ratio: Sets the unknown unicast suppression threshold as a percentage of the maximum interface rate.
The value range for this argument is 1 to 100. The smaller the percentage, the less unknown unicast
traffic is allowed to be received.