HP 830 User Manual

19
Ten-GigabitEthernet1/0/1
Ten-GigabitEthernet1/0/2
group-member
Use group-member to assign Ethernet interfaces to a port group.
Use undo group-member to remove Ethernet interfaces from the port group.
Syntax
group-member interface-list
undo group-member interface-list
Default
A port group does not contain any member ports.
Views
Port group view
Default command level
2: System level
Parameters
interface-list: Specifies an Ethernet interface list, in the form of interface-type interface-number [ to
interface-type interface-number ] &<1-10>. &<1-10> indicates that you can specify up to 10 interfaces or
interface ranges.
Usage guidelines
If you use the group-member interface-type interface-start-number to interface-type interface-end-number
command to add multiple ports in batches to the specified port group, make sure the following:
• All these ports are of the same type and on the same interface card.
• The interface-end-number argument is greater than the interface-start-number argument.
Examples
# Assign Ten-GigabitEthernet 1/0/1 to the port group named group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member ten-gigabitethernet 1/0/1
multicast-suppression
Use multicast-suppression to set the multicast suppression threshold on an Ethernet interface or a group
of Ethernet interfaces.
Use undo multicast-suppression to restore the default multicast suppression threshold.
Syntax
multicast-suppression { ratio | pps max-pps }
undo multicast-suppression

HP 830 Specifications

General

Manageable	Yes
Ports	24 x 10/100/1000 ports, 4 x SFP ports
Power Supply	Internal power supply
Operating Temperature	32°F to 113°F (0°C to 45°C)
Dimensions	17.32 x 10.24 x 1.72 in (44 x 26 x 4.37 cm)