48
[Sysname] vlan 100
[Sysname-vlan100] quit
[Sysname] interface WLAN-ESS1
[Sysname-WLAN-ESS1] port link-type hybrid
[Sysname-WLAN-ESS1] port hybrid pvid vlan 100
# Configure VLAN 100 as the PVID of the hybrid Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid pvid vlan 100
Related commands
• port hybrid vlan
• port link-type
port hybrid vlan
Use port hybrid vlan to assign a hybrid port to the specified VLANs.
Use undo port hybrid vlan to remove a hybrid port from the specified VLANs.
Syntax
port hybrid vlan vlan-list { tagged | untagged }
undo port hybrid vlan vlan-list
Default
A hybrid port only allows packets from VLAN 1 to pass through untagged.
Views
WLAN-ESS interface view, Ethernet interface view, port group view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
vlan-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a VLAN ID or a
range of VLAN IDs in the form of vlan-id1 to vlan-id2. The value range for VLAN IDs is 1 to 4094. The
value for vlan-id2 must be equal to or greater than the value for vlan-id1. Make sure the specified VLANs
already exist.
tagged: Configures the ports to send the tagged packets of the specified VLANs.
untagged: Configures the ports to send the untagged packets of the specified VLANs.
Usage guidelines
A hybrid port can allow multiple VLANs. If you execute the port hybrid vlan command multiple times, the
VLANs the hybrid port allows are the set of VLANs specified by vlan-list in each execution.
The configuration made in Ethernet or WLAN-ESS interface view applies only to the port.
The configuration made in port group view applies to all ports in the port group.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.
To Next Page
Loading...
Need help?
General
