HP 830 User Manual

63
Examples
# Add a static entry for MAC address 000f-e201-0101 on Ten-GigabitEthernet 1/0/1 that belongs to
VLAN 2.
<Sysname> system-view
[Sysname] interface Ten-GigabitEthernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] mac-address static 000f-e201-0101 vlan 2
# Add a static entry for MAC address 000f-e201-0102 on Bridge-Aggregation 1 that belongs to VLAN
1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] mac-address static 000f-e201-0102 vlan 1
Related commands
display mac-address
mac-address (system view)
Use mac-address to add or modify a MAC address entry.
Use undo mac-address to remove one or all MAC address entries.
Syntax
mac-address blackhole mac-address vlan vlan-id
mac-address { dynamic | static } mac-address interface interface-type interface-number vlan vlan-id
undo mac-address [ { dynamic | static } mac-address interface interface-type interface-number vlan
vlan-id ]
undo mac-address [ blackhole | dynamic | static ] [ mac-address ] vlan vlan-id
undo mac-address [ dynamic | static ] mac-address interface interface-type interface-number vlan
vlan-id
undo mac-address [ dy
namic | static ] interface interface-type interface-number
Default
No MAC address entry is configured.
Views
System view
Default command level
2: System level
Parameters
blackhole: Specifies destination blackhole MAC address entries. These entries do not age, but you can
add or remove them. The packets whose destination MAC addresses match destination blackhole MAC
address entries are dropped.
mac-address: Specifies a MAC address in the format of H-H-H, where 0s at the beginning of each H
(16-bit hexadecimal digit) can be omitted. For example, entering "f-e2-1" indicates that the MAC address
is "000f-00e2-0001."

HP 830 Specifications

General

Manageable	Yes
Ports	24 x 10/100/1000 ports, 4 x SFP ports
Power Supply	Internal power supply
Operating Temperature	32°F to 113°F (0°C to 45°C)
Dimensions	17.32 x 10.24 x 1.72 in (44 x 26 x 4.37 cm)