HP 830 User Manual

2
default
Use default to restore the default settings for an Ethernet interface.
Syntax
default
Views
Ethernet interface view
Default command level
2: System level
Usage guidelines
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of the
impacts of this command when you use it in a live network.
This command might fail to restore the default settings for some commands for reasons such as command
dependencies and system restrictions. Use the display this command in interface view to identify these
commands, and then use their undo forms or follow the command reference to individually restore their
default settings. If your restoration attempt still fails, follow the error message instructions to resolve the
problem.
Examples
# Restore the default settings for interface Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] default
This command will restore the default settings. Continue? [Y/N]:y
description
Use description to change the description of the interface.
Use undo description to restore the default.
Syntax
description text
undo description
Default
The default description of an interface is the interface name plus Interface. For example,
Ten-GigabitEthernet1/0/1 Interface.
Views
Ethernet interface view
Default command level
2: System level

HP 830 Specifications

General

Manageable	Yes
Ports	24 x 10/100/1000 ports, 4 x SFP ports
Power Supply	Internal power supply
Operating Temperature	32°F to 113°F (0°C to 45°C)
Dimensions	17.32 x 10.24 x 1.72 in (44 x 26 x 4.37 cm)