HP 830 User Manual

81
port link-aggregation group
Use port link-aggregation group to assign an Ethernet interface to an aggregation group.
Use undo port link-aggregation group to remove an Ethernet interface from the aggregation group to
which it belongs.
Syntax
port link-aggregation group number
undo port link-aggregation group
Views
Ethernet interface view
Default command level
2: System level
Parameters
number: Specifies the number of an existing aggregate interface corresponding to an aggregation
group. The value range varies by device model. For more information, see About the Command
References for HP Unified Wired-WLAN Products.
Usage guidelines
A Layer 2 Ethernet interface can be assigned to a Layer 2 aggregation group only.
An Ethernet interface can belong to only one aggregation group.
Examples
# Assign Layer 2 Ethernet interface Ten-GigabitEthernet 1/0/1 to Layer 2 aggregation group 1.
<Sysname> system-view
[Sysname] interface Ten-GigabitEthernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] port link-aggregation group 1
reset counters interface
Use reset counters interface to clear statistics for the specified aggregate interfaces.
Syntax
reset counters interface [ bridge-aggregation [ interface-number ] ]
Views
User view
Default command level
2: System level
Parameters
bridge-aggregation: Clears statistics for Layer 2 aggregate interfaces.
interface-number: Specifies an existing Layer 2 aggregate interface by its number. The value range
varies by device model. For more information, see About the Command References for HP Unified
Wired-WLAN Products.

HP 830 Specifications

General

Manageable	Yes
Ports	24 x 10/100/1000 ports, 4 x SFP ports
Power Supply	Internal power supply
Operating Temperature	32°F to 113°F (0°C to 45°C)
Dimensions	17.32 x 10.24 x 1.72 in (44 x 26 x 4.37 cm)