HP 830 User Manual

118
<Sysname> system-view
[Sysname] lldp compliance cdp
Related commands
• lldp hold-multiplier
• lldp timer tx-interval
lldp enable
Use lldp enable to enable LLDP.
Use undo lldp enable to disable LLDP.
Syntax
lldp enable
undo lldp enable
Default
LLDP is enabled on a port and disabled globally.
Views
System view, Layer 2 Ethernet interface view, port group view
Default command level
2: System level
Usage guidelines
LLDP takes effect on a port only when LLDP is enabled both globally and on the port.
Examples
# Disable LLDP on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] undo lldp enable
lldp encapsulation snap
Use lldp encapsulation snap to configure the encapsulation format for LLDP frames as SNAP on a port or
a group of ports.
Use undo lldp encapsulation to restore the default encapsulation format for LLDP frames.
Syntax
lldp encapsulation snap
undo lldp encapsulation
Default
Ethernet II is the encapsulation format for LLDP frames.
Views
Layer 2 Ethernet interface view, port group view

HP 830 Specifications

General

Manageable	Yes
Ports	24 x 10/100/1000 ports, 4 x SFP ports
Power Supply	Internal power supply
Operating Temperature	32°F to 113°F (0°C to 45°C)
Dimensions	17.32 x 10.24 x 1.72 in (44 x 26 x 4.37 cm)