HP 830 User Manual

91
PPPoE server commands
Support for the commands in this chapter depends on the device model. For more information, see About
the Command References for HP Unified Wired-WLAN Products.
display pppoe-server session
Use display pppoe-server session to display information about PPPoE sessions on a device operating as
a PPPoE server.
Syntax
display pppoe-server session all [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
all: Displays all the information about PPPoE sessions.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Examples
# Display all the information about PPPoE sessions. (Assume the current device is operating as a PPPoE
server.)
<Sysname> display pppoe-server session all
Total PPPoE Session(s): 2
SID Intf State OIntf RemMAC LocMAC
1 Virtual-Template1:0 UP Vlan2 00e015004100 00e014004300
2 Virtual-Template2:0 UP Vlan2 00e016004100 00e015004300
Table 21 Command output
Field Descri
p
tion
SID PPPoE session ID.
Intf Virtual-template interface.
State PPPoE session state.

HP 830 Specifications

General

Manageable	Yes
Ports	24 x 10/100/1000 ports, 4 x SFP ports
Power Supply	Internal power supply
Operating Temperature	32°F to 113°F (0°C to 45°C)
Dimensions	17.32 x 10.24 x 1.72 in (44 x 26 x 4.37 cm)