HP 830 User Manual

49
• If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
• If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
Examples
# Configure WLAN-ESS 1 as a hybrid port to forward packets from VLAN 2, VLAN 4, and VLAN 50
through VLAN 100 tagged.
<Sysname> system-view
[Sysname] interface WLAN-ESS1
[Sysname-WLAN-ESS1] port link-type hybrid
[Sysname-WLAN-ESS1] port hybrid vlan 2 4 50 to 100 tagged
# Configure ports in port group 2 as hybrid ports to forward packets from VLAN 2 untagged.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] quit
[Sysname] port-group manual 2
[Sysname-port-group-manual-2] group-member Ten-GigabitEthernet1/0/1 to
Ten-GigabitEthernet1/0/2
[Sysname-port-group-manual-2] port link-type hybrid
[Sysname-port-group-manual-2] port hybrid vlan 2 untagged
Configuring Ten-GigabitEthernet1/0/1... Done.
Configuring Ten-GigabitEthernet1/0/2... Done.
# Configure Layer 2 aggregate interface Bridge-Aggregation 1 and its member ports as hybrid ports to
forward packets from VLAN 2 untagged.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid vlan 2 untagged
Please wait... Done.
Configuring Ten-GigabitEthernet1/0/1... Done.
Configuring Ten-GigabitEthernet1/0/2... Done.
Related commands
port link-type
port link-type
Use port link-type to configure the link type of a port.
Use undo port link-type to restore the default link type of a port.
Syntax
port link-type { access | hybrid | trunk }
undo port link-type
Default
Each port is an access port.

HP 830 Specifications

General

Manageable	Yes
Ports	24 x 10/100/1000 ports, 4 x SFP ports
Power Supply	Internal power supply
Operating Temperature	32°F to 113°F (0°C to 45°C)
Dimensions	17.32 x 10.24 x 1.72 in (44 x 26 x 4.37 cm)