120
Default
The TTL multiplier is 4.
Views
System view
Default command level
2: System level
Parameters
value: Sets the TTL multiplier, ranging from 2 to 10.
Usage guidelines
You can set the TTL of the local device information by configuring the TTL multiplier.
The TTL configuration of a device is determined by the expression:
TTL multiplier × LLDP frame transmission interval
The TTL can be up to 65535 seconds. Longer TTLs will be rounded off to 65535 seconds.
Examples
# Set the TTL multiplier to 6.
<Sysname> system-view
[Sysname] lldp hold-multiplier 6
Related commands
lldp timer tx-interval
lldp management-address-format string
Use lldp management-address-format string to encapsulate the management address in the form of
strings in TLVs.
Use undo lldp management-address-format to restore the default.
Syntax
lldp management-address-format string
undo lldp management-address-format
Default
The management address is encapsulated in the form of numbers in TLVs.
Views
Layer 2 Ethernet interface view, port group view
Default command level
2: System level
Examples
# Configure Ten-GigabitEthernet 1/0/1 to encapsulate the management address in the form of strings
in management address TLVs.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet1/0/1
To Next Page
Loading...
