HP 830

119
Default command level
2: System level
Usage guidelines
The command does not apply to LLDP-CDP packets, which use only SNAP encapsulation.
Examples
# Configure the encapsulation format for LLDP frames as SNAP on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] lldp encapsulation snap
lldp fast-count
Use lldp fast-count to set the number of the LLDP frames sent each time fast LLDP frame transmission is
triggered.
Use undo lldp fast-count to restore the default.
Syntax
lldp fast-count count
undo lldp fast-count
Default
The number is 3.
Views
System view
Default command level
2: System level
Parameters
count: Sets the number of the LLDP frames sent each time fast LLDP frame transmission is triggered. The
argument ranges from 1 to 10.
Examples
# Configure the device to send four LLDP frames each time fast LLDP frame transmission is triggered.
<Sysname> system-view
[Sysname] lldp fast-count 4
lldp hold-multiplier
Use lldp hold-multiplier to set the TTL multiplier.
Use undo lldp hold-multiplier to restore the default.
Syntax
lldp hold-multiplier value
undo lldp hold-multiplier