HP 830

122
Default
LLDP trapping is disabled on ports.
Views
Layer 2 Ethernet interface view, port group view
Default command level
2: System level
Examples
# Enable LLDP trapping for Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] lldp notification remote-change enable
lldp timer notification-interval
Use lldp timer notification-interval to set the LLDP trap transmission interval.
Use undo lldp timer notification-interval to restore the default.
Syntax
lldp timer notification-interval interval
undo lldp timer notification-interval
Default
The LLDP trap transmission interval is 5 seconds.
Views
System view
Default command level
2: System level
Parameters
interval: Sets the LLDP trap transmission interval, ranging from 5 to 3600 seconds.
Examples
# Set the LLDP trap transmission interval to 8 seconds.
<Sysname> system-view
[Sysname] lldp timer notification-interval 8
lldp timer reinit-delay
Use lldp timer reinit-delay to set the LLDP re-initialization delay.
Use undo lldp timer reinit-delay to restore the default.
Syntax
lldp timer reinit-delay delay
undo lldp timer reinit-delay