56
Examples
# Enable the MAC-based VLAN feature on WLAN-ESS 1.
<Sysname> system-view
[Sysname] interface WLAN-ESS1
[Sysname–WLAN-ESS1] mac-vlan enable
mac-vlan mac-address
Use mac-vlan mac-address to associate the specified VLAN and priority value with the specified MAC
addresses.
Use undo mac-vlan to remove the association.
Syntax
mac-vlan mac-address mac-address [ mask mac-mask ] vlan vlan-id [ priority pri ]
undo mac-vlan { all | mac-address mac-address [ mask mac-mask ] | vlan vlan-id }
Default
The hexadecimal digits of this argument are all Fs.
Views
System view
Default command level
2: System level
Parameters
mac-address mac-address: Specifies a MAC address.
mask mac-mask: Specifies a mask for the MAC address in the format of H-H-H. The mac-mask argument
is comprised of the high-order part (all the binary bits of which are 1s) and the low-order part (all the
binary bits of which are 0s).
vlan vlan-id: Specifies a VLAN ID in the range of 1 to 4094.
priority pri: Specifies the 802.1p priority value corresponding to the specified MAC address. The pri
argument is in the range of 0 to 7.
all: Removes all the static MAC address-to-VLAN entries.
Usage guidelines
Two MAC address-to-VLAN entry tables exist in a device. One table contains the MAC address-to-VLAN
entries configured with the mask keyword specified. A MAC address-to-VLAN entry of this type describes
the relationship between a group of MAC addresses and a VLAN, and a priority value. Another table
contains the MAC address-to-VLAN entries configured without the mask keyword specified. A MAC
address-to-VLAN entry of this type describes the relationship between a single MAC address and a
VLAN, and a priority value. The system adds or removes MAC address-to-VLAN entries to or from the two
tables according to the configuration.
Examples
# Associate a single MAC address 0-1-1 with VLAN 100 and 802.1p priority 7.
<Sysname> system-view
[Sysname] mac-vlan mac-address 0-1-1 vlan 100 priority 7
To Next Page
Loading...
Need help?
General
