HP 830

53
Examples
# Configure VLAN 100 as the PVID of the trunk port Ten-GigabitEthernet 1/0/1, and assign
Ten-GigabitEthernet 1/0/1 to VLAN 100.
<Sysname> system-view
[Sysname] interface Ten-GigabitEthernet1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] port link-type trunk
[Sysname-Ten-GigabitEthernet1/0/1] port trunk pvid vlan 100
[Sysname-Ten-GigabitEthernet1/0/1] port trunk permit vlan 100
# Configure VLAN 100 as the PVID of the trunk Layer 2 aggregate interface Bridge-Aggregation 1, and
assign Bridge-Aggregation 1 to VLAN 100.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type trunk
[Sysname-Bridge-Aggregation1] port trunk pvid vlan 100
[Sysname-Bridge-Aggregation1] port trunk permit vlan 100
Related commands
• port link-type
• port trunk permit vlan
MAC-based VLAN configuration commands
display mac-vlan
Use display mac-vlan to display the specified MAC address-to-VLAN entries.
Syntax
display mac-vlan { all | dynamic | mac-address mac-address [ mask mac-mask ] | static | vlan vlan-id }
[ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
all: Displays all the MAC address-to-VLAN entries.
dynamic: Displays dynamically configured MAC address-to-VLAN entries.
mac-address mac-address: Displays the MAC address-to-VLAN entry containing the specified MAC
address.
mask mac-mask: Displays the MAC address-to-VLAN entries with their MAC addresses in the specified
range.
static: Displays the statically configured MAC address-to-VLAN entries.
vlan vlan-id: Displays the MAC address-to-VLAN entries associated with the specified VLAN.