HP 830

77
Default command level
2: System level
Usage guidelines
To make this command take effect, you must enable linkUp/linkDown trap generation globally with the
snmp-agent trap enable [ standard [ linkdown | linkup ] * ] command.
For more information about the snmp-agent trap enable command, see Network Management and
Monitoring Command Reference.
Examples
# Enable linkUp/linkDown trap generation on Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] snmp-agent trap enable
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] enable snmp trap updown
interface bridge-aggregation
Use interface bridge-aggregation to create a Layer 2 aggregate interface and enter Layer 2 aggregate
interface view.
Use undo interface bridge-aggregation to delete a Layer 2 aggregate interface.
Syntax
interface bridge-aggregation interface-number
undo interface bridge-aggregation interface-number
Views
System view
Default command level
2: System level
Parameters
interface-number: Specifies a Layer 2 aggregate interface by its number. The value range varies by
device model. For more information, see About the Command References for HP Unified Wired-WLAN
Products.
Usage guidelines
When you create a Layer 2 aggregate interface, a Layer 2 aggregation group with the same number is
automatically created.
Deleting a Layer 2 aggregate interface also deletes the Layer 2 aggregation group. At the same time, the
member ports of the aggregation group, if any, leave the aggregation group.
Examples
# Create Layer 2 aggregate interface Bridge-Aggregation 1 and enter its view.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1]