HP 830 User Manual

93
Default
The upper threshold for the PPPoE abnormal offline event percentage in 5 minutes is 100.
Views
System view
Default command level
2: System level
Parameters
number: Specifies the upper threshold for the PPPoE abnormal offline event percentage, in the range of
0 to 100.
Usage guidelines
If the PPPoE abnormal offline event percentage in the last 5 minutes exceeds this threshold, the system
outputs a trap message.
PPPoE abnormal offline event percentage = 100 x Abnormal offline event count/(Abnormal offline event
count + Normal offline event count).
Examples
# Set the upper threshold for the PPPoE abnormal offline event percentage to 10.
<Sysname> system-view
[Sysname] pppoe-server abnormal-offline-percent threshold 10
Related commands
pppoe-server normal-offline-percent threshold
pppoe-server bind
Use pppoe-server bind to enable PPPoE on a VLAN interface and bind the VLAN interface to a VT
interface.
Use undo pppoe-server bind to disable PPPoE on a VLAN interface.
Syntax
pppoe-server bind virtual-template number
undo pppoe-server bind
Default
PPPoE is disabled.
Views
Interface view
Default command level
2: System level
Parameters
virtual template number: Specifies a VT interface by its number in the range of 0 to 1023.
Examples
# Enable PPPoE on interface Vlan-interface 1 and bind the VLAN interface to interface VT 1.

HP 830 Specifications

General

Manageable	Yes
Ports	24 x 10/100/1000 ports, 4 x SFP ports
Power Supply	Internal power supply
Operating Temperature	32°F to 113°F (0°C to 45°C)
Dimensions	17.32 x 10.24 x 1.72 in (44 x 26 x 4.37 cm)