HP 830 User Manual

78
lacp period short
Use lacp period short to set the LACP timeout interval to the short timeout interval (1 second) on a port.
Use undo lacp period to restore the default.
Syntax
lacp period short
undo lacp period
Default
The LACP timeout interval is the long timeout interval (30 seconds).
Views
Ethernet interface view
Default command level
2: System level
Examples
# Set the LACP timeout interval to the short timeout interval (1 second) on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] lacp period short
lacp system-priority
Use lacp system-priority to set the LACP priority of the local system.
Use undo lacp system-priority to restore the default.
Syntax
lacp system-priority system-priority
undo lacp system-priority
Default
The system LACP priority is 32768.
Views
System view
Default command level
2: System level
Parameters
system-priority: Specifies the LACP priority of the local system, in the range of 0 to 65535. The smaller the
value, the higher the system LACP priority.
Examples
# Set the system LACP priority to 64.
<<Sysname> system-view
[Sysname] lacp system-priority 64

HP 830 Specifications

General

Manageable	Yes
Ports	24 x 10/100/1000 ports, 4 x SFP ports
Power Supply	Internal power supply
Operating Temperature	32°F to 113°F (0°C to 45°C)
Dimensions	17.32 x 10.24 x 1.72 in (44 x 26 x 4.37 cm)