HP 830 User Manual

39
interface vlan-interface
Use interface vlan-interface to create a VLAN interface and enter its view or enter the view of an existing
VLAN interface.
Use undo interface vlan-interface to remove the specified VLAN interface.
Syntax
interface vlan-interface vlan-interface-id
undo interface vlan-interface vlan-interface-id
Views
System view
Default command level
2: System level
Parameters
vlan-interface-id: Specifies a VLAN interface number in the range of 1 to 4094.
Usage guidelines
Create the VLAN before you create the VLAN interface.
To configure an IP address for a VLAN interface that will perform IP routing, use the ip address command
in VLAN interface view.
Examples
# Create VLAN-interface 2, and enter its view.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] quit
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2]
Related commands
display interface vlan-interface
ip address
Use ip address to assign an IP address and subnet mask to a VLAN interface.
Use undo ip address to remove the IP address and subnet mask for a VLAN interface.
Syntax
ip address ip-address { mask | mask-length } [ sub ]
undo ip address [ ip-address { mask | mask-length } [ sub ] ]
Default
No IP address is assigned to a VLAN interface.
Views
VLAN interface view

HP 830 Specifications

General

Manageable	Yes
Ports	24 x 10/100/1000 ports, 4 x SFP ports
Power Supply	Internal power supply
Operating Temperature	32°F to 113°F (0°C to 45°C)
Dimensions	17.32 x 10.24 x 1.72 in (44 x 26 x 4.37 cm)