HP 9000 Superdome - Attaching Rear Kick Plates

Chapter 4
Verifying and Booting Superdome
Attaching Rear Kick Plates
98
Attaching Rear Kick Plates
Kick plates serve the practical purpose of protecting cables from accidentally being disconnected or damaged,
as well as add an attractive cosmetic touch to the SPU cabinet. There are three metal pieces to attach to the
bottom rear of the cabinet.
To install the kick plates:
Step 1. Hold the left kick plate(A5201-0671) in position and attach a clip nut (0590-2318) on the cabinet
column next to the hole in the flange at the top of the kick plate.
Step 2. Using a screw (0515-0671) and a T25 Torx driver, attach the flange on the kick plate to the nut clip.
Step 3. Using a Torx 10 driver and a screw (0515-4271), attach the bottom of the kick plate to the center
hole in the leveling foot.
Figure 4-7Attaching Rear Kick Plates
Step 4. Perform steps 1-3 on the right kick plate (A5201-00281).
60IN078A
9/12/00
L
3
-
L
1
L
1
-
L
2
L
2
-
L
3
L
2
-
L
3
L
1
-
L
2
L
3
-
L
1