Chapter 3
Preparing Superdome for Booting
Installing the Front Door Bezels and the Front and Back Blower Bezels
45
Step 2. Slide the bezel over the blower housing frame, hooking the lip of the bezel onto the cross support of
the blower housing, hold the bottom of the bezel. Rotate the bezel from the top a until the bottom
snaps in place.
Figure 3-12Installing the Rear Blower Bezel
Step 3. Align the bezel over the nuts that are attached to the bracket at the rear of the cabinet.
Step 4. Using a T20 Torx driver, tighten the two captive screws on the lower flange of the bezel.
NOTE Tighten the screws securely, otherwise the screw may interfere with your ability to
close the door.
Step 5. Close the cabinet rear door.
Installing the Front Blower Bezel
The front blower bezel is a cosmetic cover for the blowers and is located above the front door. To install it, use
the following procedure:
Step 1. If you have not already done so, open the front door.
60IN053A
5/31/01
To Next Page
Loading...
