EasyManua.ls Logo

HP 9000 Superdome - Attaching Side Skins and Blower Side Bezels; Attaching the Side Skins

HP 9000 Superdome
260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 3
Preparing Superdome for Booting
Attaching Side Skins and Blower Side Bezels
36
Attaching Side Skins and Blower Side Bezels
There are two cosmetic side panels that affix to the left and right sides of the Superdome system. In addition,
there are bezels that cover the sides of the blowers. (Later in the installation process you will be given
instructions on how to attach front and back blower bezels.)
IMPORTANT Be sure to attach the side skins at this time in the installation sequence, especially if the
Superdome is to be positioned at the end of a row of cabinets or between cabinets.
Attaching the Side Skins
There are four side skins: two front-side skins and two rear-side skins.
NOTE For Superdome 64 Way systems, you attach side skins to the left side of Cabinet 0 and the right
side of Cabinet 1.
To attach the side skins:
Step 1. Remove the side skins from their boxes and protective coverings, if you have not already done so.
Step 2. From the end of the brackets at the back of the cabinet, position the side skin with the lap joint
(rear) over the top bracket and under the bottom bracket, and gently slide it into position.

Table of Contents

Related product manuals