HP 9000 Superdome - Command Line Arguments

Appendix H
JUST Exploration Tool
Command Line Arguments
208
Command Line Arguments
JET supports the following command line arguments:
These options are specified using the following format:
jet [ -v ] [ -h ] [ -d <debug level> ] [ -f <complex name> <node number> ] [ -i ]
Table H-1 Command Line Arguments
Argument Parameters Description
-v Prints version information then exit.
-d <debug level> Specifies JET debug level. This parameter overrides any other
specification of debug level.
-h (lower case h) Prints short help page.
-f <complex name>
<node number>
Causes a forced disconnect from the specified node in the specified
complex.
-i Enter interactive mode.
-o Outputs the old format complex.cfg configuration file. The default is
to output the new format cplx.cfg file.
-r Performs a JTAG reset on each path before scanning the ID rings. The
default is to not perform the reset.