Chapter 3
Preparing Superdome for Booting
Installing the Front Door Bezels and the Front and Back Blower Bezels
44
Step 6. While one person holds the upper door bezel near the door chassis, attach the ribbon cable to the
back of the control panel on the bezel and tighten the two flathead screws.
Figure 3-11Installing the Upper Front Door Assembly
Step 7. Insert the shoulder studs on the upper door bezel into the holes on the front door metal chassis.
Step 8. Using a Torx 10 driver, secure the upper door bezel to the metal door with eight of the screws
provided, part number 0515-0372. Be sure to hold down on the hinge side of the bezel while
tightening the screws to prevent misalignment of the bezel.
Installing the Rear Blower Bezel
The rear blower bezel is a cosmetic cover for the blowers and is located above the rear door.
To install the rear blower bezel:
Step 1. If you have not already done so, open the rear cabinet door.
The latch is located on the right side of the door.
11/7/00
60IN049A
Front Panel Display Cable
To Next Page
Loading...
