Appendix F
A180 Support Management Station
Setting Up the A180 Support Management Station Using the Web Console or the Serial Port
172
Setting Up the A180 Support Management Station Using the Web
Console or the Serial Port
You can access the Support Management Station (SMS) to configure it in two ways: using the Web console
port or using the serial console port. The method you choose depends on whether the customer has given you
an IP address for the Web console. If you have an IP address for the Web console, refer to “Setting Up the
A180 SMS Using the Web Console Port,” which follows. If you don’t have an IP address for the Web console,
refer to “Setting Up the A180 SMS Using the CE Tool” on page 174.
Setting Up the A180 SMS Using the Web Console Port
Setting up the SMS using the Web console port requires a customer-supplied IP address. If you do not have
an IP address for the Web console, skip to “Setting Up the A180 SMS Using the CE Tool” on page 174.
To set up the SMS using the Web console port:
Step 1. Connect one end of a standard LAN cable to the Web Console port on the SMS.
Figure F-2A180 Support Management Station Ports
Step 2. Connect the other end of the cable to the local network (usually a customer hub).
Regulatory Information on Bottom
SCSI (Single Ended) 8/16/5
LAN Web Console
Web
Console
Reset
Console 8/16/4.0
Transfer
of
Control
LAN 10/100 Base-T 8/0/20/0
MAC Address
Product Number
Model
HP 9000 A-Class
HSC
OR
PCI
LAN StationAddress
Serial Number
Product Number
90-240V~
47-63Hz,3.6A
A5187A
A5187A
USJ xxxxxxx
xxxxxx-xxxxxx
xxxxxx-xxxxxx
A180C
LAN 0
Private LAN
LAN 1
Customer LAN
WEB
Console
Single Ended SCSI
Connection to I/O
Serial Connection
to CE Laptop
To Next Page
Loading...
