Chapter 3
Preparing Superdome for Booting
Installing the Front Door Bezels and the Front and Back Blower Bezels
42
Installing the Front Door Bezels and the Front and Back Blower
Bezels
There are two doors: one at the front and one at the back. The back door is shipped on the chassis and
requires no assembly. T he front door, which is also shipped on the chassis, requires the assembly of two
plastic bezels to its front surface and a cable from the door to the upper front bezel. In addition, there are
bezels that fit over the blowers at the front and back of the SPU cabinet.
Installing the Front Door Bezels
The front door assembly includes two cosmetic covers, a control panel, and a key lock. Installing the front
door is a three-step process: connecting the control panel ribbon cable from the chassis to the control panel,
and mounting the two plastic bezels onto the metal chassis door.
NOTE The procedure in this section requires two people and must be performed with the front metal
chassis door open.
To install the front door assembly:
Step 1. Open the door, unsnap the screen, and remove the filter.
Step 2. Remove the SPU cabinet keys that are taped inside the top front door bezel.
To Next Page
Loading...
