Appendix A
hp Server rx2600 Support Management Station
Configuring the SMS
144
Configuring the Operating System
Perform the following to configure HP-UX 11i-v2:
Step 1. From the EFI boot manager menu, boot the operating system by selecting HP-UX Primary Boot at
the EFI menu.
When the system boots to set_parms, the following menu appears.
Figure A-17set_parms Menu
Step 2. Set the root password.
The default password serialbus.
Step 3. Enter the following data when prompted.
• IP addresses
•Host name
• Global network mask
• Gateway router IP address
Step 4. Using the bdf command, verify that these parameters are set as follows:
• /tmp = 1000 MB
• /opt = 6900 MB
Step 5. Verify that the DVD and DAT drives are configured as per the documentation sent with the system
or set to default (DVD = 1, DAT = 3). Enter the following at the prompt:
# ioscan -fn
Step 6. If the DAT drive is not claimed by the operating system, enable it by entering kcmodule
stape=static, to reboot the SMS.
To Next Page
Loading...
