Appendix D
Connecting a CE Tool to the GSP Using the Customer LAN
162
body of the manual.
This procedure, which assumes that you are using a laptop running Reflection 1 with a crossover cable,
allows you to display multiple windows to communicate by connecting to the customer’s hub with a
regular ethernet LAN cable. The disadvantage to this method is that unless you are on the same subnet as
the customer, you have to reconfigure your laptop, and reconfigure it again after you have completed the
installation.
To connect to the GSP using the customer LAN and a laptop:
NOTE To make this connection you need a LAN crossover cable (HP Part Number M3199-60102M).
Step 1. Connect one end of the LAN cable to the Customer LAN port on the GSP.
Figure D-1RJ-45 LAN and RS-232 Connectors in SPU Cabinet
Step 2. Connect the other end of the LAN cable to the LAN card adapter on the laptop.
Step 3. If you have not already done so, turn on your laptop.
Step 4. Set up a communications link with the GSP.
NOTE Do not use Direct Host Connect Protocol (DHCP) for the LAN profile on your laptop.
It can lead to network communication failures.
60IN050A
9/8/00
LAN and
RS-232 Connectors
Local
RS232
Remote
RS232
LAN
Customer
LAN
Private
To Next Page
Loading...
