Chapter 3
Preparing Superdome for Booting
Attaching Side Skins and Blower Side Bezels
39
Step 1. Place the side bezel slightly above the blower housing frame.
Figure 3-8 Attaching the Side Bezels and Blower Bracket Locks
Step 2. Align the lower bezel tabs to the slots in the side panels.
Step 3. Lower the bezel so the bezel top lip fits securely on the blower housing frame and the two lower
tabs are fully inserted into the side panel slots.
Step 4. Using a Torx 10 drive, attach the screws (HP P/N 0515-4271) to secure the skins to the top and
bottom brackets.
11/10/00
60IN044A
Tab (2)
Slots
Blower Side Bezel
See Detail
Lip
Blower Bracket Locks
To Next Page
Loading...
