Chapter 3
Preparing Superdome for Booting
Removing the EMI Panels
54
NOTE If you are installing a Superdome 64 Way, you can skip the remaining steps in this
section and continue on to “Installing the Support Management Station (SMS)” on
page 55.
Step 3. Loosen the captive screw at the lower center of the back EMI panel.
Figure 3-20Removing the Back EMI Panel
Step 4. Use the handle provided to gently remove the EMI panel; then, set it aside.
NOTE If you are installing a Support Management Station, continue on to the next section. If not, go
to “Verifying and Booting Superdome” on page 79.
60IN025A
9/8/00
L
2
-L
3
L
1
-
L
2
L
3
-L
1
L
2
-L
3
L
1
-
L
2
L
3
-
L
1
Back EMI Panel Screw
To Next Page
Loading...
