To Next Page

To Previous Page

[SwitchA] interface vlan-interface 104

[SwitchA-Vlan-interface104] pim dm

[SwitchA-Vlan-interface104] igmp enable

[SwitchA-Vlan-interface104] quit

# Create QoS policy policy1 to block multicast flows from Source 2 to 224.1.1.1.

[SwitchA] acl number 3001

[SwitchA-acl-adv-3001] rule permit udp source 2.1.1.1 0 destination 224.1.1.1 0

[SwitchA-acl-adv-3001] quit

CAUTION:

hen confi

urin

a multicast source control policy, you need to apply an advanced ACL to match both

the multicast source address and destination address. Otherwise, multicast packets expected to be

filtered out will still be forwarded.

[SwitchA] traffic classifier classifier1

[SwitchA-classifier-classifier1] if-match acl 3001

[SwitchA-classifier-classifier1] quit

CAUTION:

Do not reference any IPv6 ACL after an IPv4 ACL is referenced in classifier view. Otherwise, match

errors will occur.

[SwitchA] traffic behavior behavior1

[SwitchA-behavior-behavior1] filter deny

[SwitchA-behavior-behavior1] quit

[SwitchA] qos policy policy1

[SwitchA-qospolicy-policy1] classifier classifier1 behavior behavior1

[SwitchA-qospolicy-policy1] quit

# Create user profile profile1, apply QoS policy policy1 to the inbound direction in user profile view,

and enable the user profile.

[SwitchA] user-profile profile1

[SwitchA-user-profile-profile1] qos apply policy policy1 inbound

[SwitchA-user-profile-profile1] quit

[SwitchA] user-profile profile1 enable

# Create RADIUS scheme scheme1; set the service type for the RADIUS server to extended; specify the IP

addresses of the primary authentication/authorization server and accounting server as 3.1.1.1; set the

shared keys to 123321; specify that no domain name is carried in a username sent to the RADIUS

server.

[SwitchA] radius scheme scheme1

[SwitchA-radius-scheme1] server-type extended

[SwitchA-radius-scheme1] primary authentication 3.1.1.1

[SwitchA-radius-scheme1] key authentication 123321

[SwitchA-radius-scheme1] primary accounting 3.1.1.1

[SwitchA-radius-scheme1] key accounting 123321

[SwitchA-radius-scheme1] user-name-format without-domain

[SwitchA-radius-scheme1] quit

Questions and Answers:

Need help?

Do you have a question about the HP A5500 SI Switch Series and is the answer not in the manual?

HP A5500 SI Switch Series Specifications

General

Layer Support	Layer 2 and Layer 3
MAC Address Table	16K entries
Routing Protocol	RIP, OSPF, BGP, IS-IS
Management	Web, CLI, SNMP
Input Voltage	100-240 V AC
Operating Temperature	0°C to 45°C
Ports	48 x 10/100/1000 ports, 4 x 10-Gigabit SFP+ ports
Dimensions	440 x 430 x 44 mm
Weight	5.5 kg
Operating Humidity	10% to 95% (non-condensing)