7–6 User’s Guide
Using Wi-Fi
2. On the iPAQ Wireless screen, tap the Wi-Fi button to turn it
on, then tap the Settings button next to it.
3. Tap the Wireless tab > Add New Settings.
4. Tap the General tab and enter a network name (SSID).
NOTE: If a network was detected in step 2, the SSID is
automatically entered and cannot be changed.
5. In the Connects to: box, select where your network connects
to (The Internet or Work).
6. If you want to connect to an ad-hoc connection, tap the This
is a device-to-computer (ad-hoc) connection checkbox.
7. If authentication information is needed, from the Settings
screen, tap Configure Wireless Networks.
NOTE: To determine whether authentication information is
needed, see your network administrator.
8. In the box next to Authentication:, tap the arrow for the
drop-down list, and select the type of network authentication
to use.
a. In the box next to Data Encryption, tap the arrow for the
drop-down list, and select the type of Data encryption
(WEP enabled) to use.
b. If a network key is provided by your network
automatically, check the The Key is provided for
me automatically checkbox.
c. To use Shared Key authentication, type the network key
in the Network Key: box.
d. For increased security, check the Enable network
access using IEEE 802.1X checkbox. You should
only check this option if it is supported by your network
environment. Ask your network administrator if you are
unsure.
To Next Page
Loading...
Need help?
General
