Regulatory Notices
User’s Guide A–9
energy for the general population. The guidelines are based on the
safety standards previously set by both the United States and
international standards:
This equipment under test has been shown to be capable of
compliance for localized Specific Absorption Rate (SAR) for
uncontrolled environment/general population exposure limits
specified in ANSI/IEEE Standard C95.1-1992 and had been
tested in accordance with measurement procedures specified in
FCC/OET Bulletin 65 Supplement C (2001) and IEEE Standard
1528-200X (Draft 6.5, January 2002). Ministry of Health
(Canada), Safety Code 6. The standards include a substantial
safety margin designed to assure the safety of all persons,
regardless of age and health. The exposure standard for wireless
mobile phones employs a unit of measure known as the Specific
Absorption Rate (SAR). The SAR limit set by the FCC is
1.6W/kg.
NOTE: In the U.S. and Canada, the SAR limit for mobile phones
used by the public is 1.6 watts/kg (W/kg) averaged over one gram
of tissue. The standard incorporates a substantial margin of safety
to give additional protection to the public and to account for any
variations.
Canadian Regulatory Wireless Notice
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
Australian Wireless Notice
Ã…
WARNING: Switch off this device whenever in an area with a
potentially explosive atmosphere (i.e., service stations, chemical plants,
etc.).
To Next Page
Loading...
Need help?
General
